User's Manual
Table Of Contents
- ProSafe Dual Band Wireless-N Access Point WNDAP360
- Contents
- 1. Introduction
- 2. Installation and Basic Configuration
- 3. Wireless Configuration and Security
- 4. Management
- 5. Advanced Configuration
- 6. Troubleshooting
- Basic Functioning
- You Cannot Access the Internet or the LAN from a Wireless-Capable Computer
- You Cannot Configure the Wireless Access Point from a Browser
- When You Enter a URL or IP Address a Time-Out Error Occurs
- Troubleshooting a TCP/IP Network Using the Ping Utility
- Problems with Date and Time
- Use the Packet Capture Tool
- A. Supplemental Information
- B. Command-Line Reference
- C. Notification of Compliance
- Index
Management
69
ProSafe Dual Band Wireless-N Access Point WNDAP360
Enable the Syslog Server
The Syslog screen allows you to enable the syslog option if you have a syslog server on your
LAN. If syslog is enabled, the wireless access point sends its syslog files to the syslog server.
To enable a syslog server:
1. Select Conf
iguration > System > Advanced > Syslog. The Syslog screen displays:
Figure 41.
Specify the settings as explained in the following table:
2. . Click Apply to sa
ve your settings.
Monitor the Wireless Access Point
The wireless access point provides a variety of status and usage information that is
discussed in the following sections:
• View System Information
• Monitor Wireless Stations
• View the Activity Log
• Traffic Statistics
Table 17. Syslog Settings
Field Description
Enable Syslog Select the check box to enable the syslog option. By default, the syslog option
is
disabled.
Syslog Server IP Address Enter the IP address of the syslog server to which the wireless access point
sends the syslog files.
Port Number Enter the port number that is co
nfigured on the syslog server. The default port
number is 514.