User's Manual
Table Of Contents
- ProSafe Dual Band Wireless-N Access Point WNDAP360
- Contents
- 1. Introduction
- 2. Installation and Basic Configuration
- 3. Wireless Configuration and Security
- 4. Management
- 5. Advanced Configuration
- 6. Troubleshooting
- Basic Functioning
- You Cannot Access the Internet or the LAN from a Wireless-Capable Computer
- You Cannot Configure the Wireless Access Point from a Browser
- When You Enter a URL or IP Address a Time-Out Error Occurs
- Troubleshooting a TCP/IP Network Using the Ping Utility
- Problems with Date and Time
- Use the Packet Capture Tool
- A. Supplemental Information
- B. Command-Line Reference
- C. Notification of Compliance
- Index
58
4
4. Management
This chapter describes how to use the management and monitoring features of your ProSafe
Dual Band Wireless-N Access Point WNDAP360. This chapter includes the following sections:
• Enable Remote Management
• Upgrade the Wireless Access Point Software
• Manage the Configuration File or Reset to Factory Defaults
• Change the Administrator Password
• Enable the Syslog Server
• Monitor the Wireless Access Point
• Enable Rogue AP Detection and Monitor Access Points
Enable Remote Management
Both Simple Network Management Protocol (SNMP) and the remote console Secure Shell
(SSH) are enabled by default, which allows for remote management of the wireless access
point from a client running SNMP management software, as well as from a SSH client. The
Telnet console is disabled by default.