User's Manual
Table Of Contents
- ProSafe Dual Band Wireless-N Access Point WNDAP360
- Contents
- 1. Introduction
- 2. Installation and Basic Configuration
- 3. Wireless Configuration and Security
- 4. Management
- 5. Advanced Configuration
- 6. Troubleshooting
- Basic Functioning
- You Cannot Access the Internet or the LAN from a Wireless-Capable Computer
- You Cannot Configure the Wireless Access Point from a Browser
- When You Enter a URL or IP Address a Time-Out Error Occurs
- Troubleshooting a TCP/IP Network Using the Ping Utility
- Problems with Date and Time
- Use the Packet Capture Tool
- A. Supplemental Information
- B. Command-Line Reference
- C. Notification of Compliance
- Index
Wireless Configuration and Security
51
ProSafe Dual Band Wireless-N Access Point WNDAP360
Configure RADIUS Server Settings
For authentication, accounting, or both authentication and accounting using RADIUS, you
need to configure primary servers and optional secondary servers. These RADIUS server
settings can apply to all devices that are connected to the wireless access point.
To configure the RADIUS server settings:
1. Select Configura
tion > Security > Advanced > Radius Server Settings. The Radius
Server Settings screen displays. (The following figure shows some examples.)
Table 13. WPA-PSK, WPA2-PSK, and WPA-PSK & WPA2-PSK Settings
Field Descriptions
Data Encryption TKIP Temporal Key Integrity Protocol (TKIP) is the st
andard encryption method
used with WPA. You can also use TKIP with WPA2.
Note: TKIP provides only legacy (slower) rates of operation. NETGEAR
recommends WPA2 a
uthentication with AES encryption if you want to use the
11n rates and speed.
AES Advanced Encryption Standard (AES) is the stand
ard encryption method used
with WPA2.
Note: Although some wireless clients might support AES with WPA, the
WNDAP360 wireless
ac
cess point does not support WPA with AES.
TKIP + AES TKIP + AES supports both WPA and WPA2. Broadcast packets use TKIP. For
unicast (point-to-point) transmissions, WPA clients use TKIP, and WPA2
clients use AES.
For the WPA & WPA2 mixed mode, TKIP
+ AES
is the only supported data
encryption method.
Passphrase Enter a passphrase. The passphrase length needs to be between 8 and 63 characters
(inclusive). The default passphrase is sharedsecret.
You can display the actual passphrase by selecting the Show
Passphrase in Clear Text
radio button.
Show Passphrase
in Clear
Text
Select the Yes radio button to display the actual passphrase in the Passphrase field. The
default setting is No.