User's Manual
Table Of Contents
- ProSafe Dual Band Wireless-N Access Point WNDAP360
- Contents
- 1. Introduction
- 2. Installation and Basic Configuration
- 3. Wireless Configuration and Security
- 4. Management
- 5. Advanced Configuration
- 6. Troubleshooting
- Basic Functioning
- You Cannot Access the Internet or the LAN from a Wireless-Capable Computer
- You Cannot Configure the Wireless Access Point from a Browser
- When You Enter a URL or IP Address a Time-Out Error Occurs
- Troubleshooting a TCP/IP Network Using the Ping Utility
- Problems with Date and Time
- Use the Packet Capture Tool
- A. Supplemental Information
- B. Command-Line Reference
- C. Notification of Compliance
- Index
Wireless Configuration and Security
47
ProSafe Dual Band Wireless-N Access Point WNDAP360
WARNING!
If you use a wireless computer to configure wireless security
settings, you will be disconnected when you click Apply.
Reconfigure your wireless computer to match the new settings, or
access the wireless access point from a wired computer to make
further changes.
Configure an Open System with WEP or Shared Key with WEP
Wether you use an open system with WEP or shared key with WEP, specify the fields that are
explained in the following table.
• Open System with WEP
An
open system can function without any encryption or with pre-shared WEP key
encryptio
n without RADIUS authentication. The security level of static WEP is not very
strong.
When you select Open System from the Network Authen
tication drop-down list and any
selection other than None from the Data Encryption drop-down list, the screen expands to
display the WEP fields:
Figure 18.
• Shared Key with WEP
Shared key provides pre-shared WEP key encryption without RADIUS authentication.
The securit
y level of static WEP is not very strong. When you select Shared Key from the
Network Authentication drop-down list, the screen expands to display the WEP fields:
Figure 19.