User's Manual
Table Of Contents
- ProSafe Dual Band Wireless-N Access Point WNDAP360
- Contents
- 1. Introduction
- 2. Installation and Basic Configuration
- 3. Wireless Configuration and Security
- 4. Management
- 5. Advanced Configuration
- 6. Troubleshooting
- Basic Functioning
- You Cannot Access the Internet or the LAN from a Wireless-Capable Computer
- You Cannot Configure the Wireless Access Point from a Browser
- When You Enter a URL or IP Address a Time-Out Error Occurs
- Troubleshooting a TCP/IP Network Using the Ping Utility
- Problems with Date and Time
- Use the Packet Capture Tool
- A. Supplemental Information
- B. Command-Line Reference
- C. Notification of Compliance
- Index
Wireless Configuration and Security
41
ProSafe Dual Band Wireless-N Access Point WNDAP360
_________________________________________________________________________
Form for 802.11a/an modes
Store this information in a safe place:
• SSID: The
service se
t identification (SSID) identifies the wireless local area network. You
can customize it by using up to 32 alphanumeric characters. Write your SSID on the line.
SSID:
___________________________________
The SSID in the wireless access point is the SSID you configure on the wire
less adapter
card. All wireless nodes in the same network need to be configured with the same SSID.
• WEP Key Size,
Key Format Passphrase, and Authentication
Choose the key size by circling one: 64, 128, or 152 bits.
Choose the key format by circling one: ASCII or HEX.
Choose the authentication type by circling one: Open or
Shared.
Passphrase:
___________________________________
Note: If you select shared key, the other devices in the network will not connect unless
t
hey are set to shared key and have the same keys in the same positions as those in the
wireless access point.
• WP
A-PSK (Pre-Shared Key) and WPA2-PSK
Record the WP
A-PSK passphrase:
WPA-PSK Passphrase:
________________________________
Record the WPA2-PSK passphrase:
WPA2-PSK Passphrase:
________________________________
• WPA RADIUS Settings
For WPA, record the following settings for the primary and secondary RADIUS servers:
Server Name/IP Address: Primary
________________ Secondary _________________
Port:
___________________________________
Shared Secret:
___________________________________
• WPA2 RADIUS Settings
F
or WPA2, record the following settings for the primary and secondary RADIUS servers:
Server Name/IP Address: Primary
________________ Secondary _________________
Port:
___________________________________
Shared Secret:
___________________________________
_________________________________________________________________________