User's Manual
Table Of Contents
- ProSafe Dual Band Wireless-N Access Point WNDAP360
- Contents
- 1. Introduction
- 2. Installation and Basic Configuration
- 3. Wireless Configuration and Security
- 4. Management
- 5. Advanced Configuration
- 6. Troubleshooting
- Basic Functioning
- You Cannot Access the Internet or the LAN from a Wireless-Capable Computer
- You Cannot Configure the Wireless Access Point from a Browser
- When You Enter a URL or IP Address a Time-Out Error Occurs
- Troubleshooting a TCP/IP Network Using the Ping Utility
- Problems with Date and Time
- Use the Packet Capture Tool
- A. Supplemental Information
- B. Command-Line Reference
- C. Notification of Compliance
- Index
Supplemental Information
114
ProSafe Dual Band Wireless-N Access Point WNDAP360
Wireless Local Network (WLAN)
Operating mode Access point, infrastructure mode
Wireless access point name netgearxxxxxx where xxxxxx is the last 6 digit
s of the wireless
access point MAC address.
Wireless communication Enabled
11 b/g/n wireless network name (SSID) NETGEAR_11ng
Broadcast network name SSID Enabled
Security Disabled (open system)
Transmission speed Best
a
Country and region Varies by region
802.11ng radio frequency channel Auto
Output power Full
Wireless card access list All wireless stations allowed
WMM support Enabled
a. Maximum wireless signal rate derived from IEEE Standard 802.11 specifications. Actual throughput will vary. Network conditions and
environmental factors, including volume of network traffic, building materials and construction, and network overhead, lower actual data
throughput rate.
Table 30. Default Configuration Settings WNDAP360 (Continued)
Feature Description