User's Manual

Supplemental Information
112
ProSafe Dual Band Wireless-N Access Point WNDAP360
Factory Default Settings
You can use the Reset button located on the rear of the wireless access point to reset all
settings to their factory defaults. This is called a hard reset.
To perform a hard reset, use a sharp object to push and hold the Reset button fo
r
approximately 5 seconds (until the Test LED blinks rapidly). This returns t
he wireless access
point to the factory configuration settings that are shown in the following table.
Note: Pressing the Reset button for a shorter period of time simply causes
the wireless access point to reboot.
Management and Other Specifications
Network management • Remote configuration and management through the web management interface,
through SNMP, or through Telnet or SSH with the command-line interface (CLI)
• SNMP management supports SNMP MIB I, MIB II, 802.1
1 MIB and proprietary
configuration MIB
Maximum clients Limited by the amount of wireless network traf
fic generated by each node; a
maximum of 64 clients is supported.
Status LEDs • Power/Test LED
• Link speed LED
• Ethernet LAN
• Wireless LAN (2.4 GHz and 5 GHz)
Electrical and Physical S
pecifications
Power adapter 12 VDC, 1A; plug is localized to country of sale
Physical specifications • Dimensions (h x w x d): 253.75 x 253.75 x 54
.76 mm (10.0 x 10.0 x 2.16 in)
• Weight: 0.886 kg (1.95 lb)
Environmental
spec
ifications
Operating temperature: 0 to 55° C (32 to 131° F)
Operating humidity: 10–9%, noncondensing
Compliance
Note: For more information about compliance, see Appendix C, Notification of Compliance.
Electromagnetic
complianc
e
F
CC Part 15 Class B and Class E, CE, and C-TICK
Table 29. Technical Specifications WNDAP360 (Continued)
Feature Description