User's Manual

62 | Chapter 5: Advanced
Mobile Broadband 11n Wireless Router MBR1000
On the main menu, below the Advanced heading, select Wireless Repeating Function to
display the following screen:
Point-to-Point Bridge Configuration
In Point-to-Point Bridge mode, the router communicates as an access point with another
bridge-mode wireless station. The following figure shows an example of Point-to-Point Bridge
mode.
Figure 4 Point-to-Point Bridge
As a bridge, wireless client associations are disabled—only wired clients can be connected.
You must enter the MAC address of the other bridge-mode wireless station in the field
provided. Use wireless security to protect this communication.
To set up a point-to-point bridge configuration:
1. Configure the MBR1000 router (AP 1) on LAN Segment 1 in Point-to-Point Bridge mode.
Both APs (access points) are in
Point-to-Point Bridge mode.
LAN Segment 1
LAN Segment 2
192.168.0.1
AP 1 (MBRN3000 Router)
AP 2
Switch or hub
PCs
PCs
wireless PC
associated with AP 1
wireless PC
associated with AP 2