User's Manual

Chapter 7. Virtual Private Networking | 89
N600 Wireless Dual Band Gigabit ADSL2+ Modem Router DGND3700 User Manual
• Step 2: Configure the NETGEAR ProSafe VPN Client on page 92 shows how to configure
the NETGEAR ProSafe VPN client endpoint.
VPN tunnel
Internet
PC running NETGEAR
ProSafe VPN client
22.23.24.25
0.0.0.0
IP: 192.168.3.1
Figure 43. Wireless Modem Router DGND3700 Client-to-Gateway VPN Tunnel
Step 1: Configure the Client-to-Gateway VPN Tunnel
This section describes using the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in Table 16 on page 87. If you have special requirements not
covered by these VPNC-recommended parameters, see Setting Up VPN Tunnels in Special
Circumstances on page 109 for information about how to set up the VPN tunnel.
The following worksheet identifies the parameters used in this procedure. For a blank
worksheet, see Planning a VPN on page 86.
Table 17. VPN Tunnel Configuration Worksheet
Parameter Value to Be Entered Field Selection
Connection Name RoadWarrior N/A
Pre-Shared Key 12345678 N/A
Secure Association N/A Main Mode Manual Keys
Perfect Forward secrecy N/A Enabled Disabled
Encryption Protocol N/A DES 3DES
Authentication Protocol N/A MD5 SHA-1
Diffie-Hellman (DH) Group N/A Group 1 Group 2
Key Life in seconds 28800 (8 hours) N/A
IKE Life Time in seconds 3600 (1 hour) N/A
VPN Endpoint Local IPSecID LAN IP Address Subnet Mask FQDN or Gateway
IP (WAN IP
Address)
Client toGateway N/A N/A Dynamic
Gateway toClient 192.168.3.1 255.255.255.0 22.23.24.25