User's Manual
Table Of Contents
- NETGEAR Wireless N150 Access Point WN604 Reference Manual
- Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Basic Installation and Configuration
- Chapter 3
- Understanding Security Profiles
- Wi-Fi Protected Setup (WPS)
- Configuring Security Manually
- SSID and WEP/WPA Settings Setup Form
- Configuring the RADIUS Server Settings
- Setting up a Security Profile
- Configuring WEP
- Configuring WPA with RADIUS
- Configuring WPA2 with RADIUS
- Configuring WPA and WPA2 with RADIUS
- Configuring WPA-PSK
- Configuring WPA2-PSK
- Configuring WPA-PSK and WPA2-PSK
- Restricting Wireless Access by MAC Address
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting and Debugging
- No lights are lit on the wireless access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WN604 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless N150 Access Point WN604 Reference Manual
5-10 Advanced Configuration
v1.0, March 2010
A computer on either LAN segment should be able to connect to the Internet or share files and
printers of any other PCs or servers connected to LAN Segment 1 or LAN Segment 2.
6. Click Apply to save your settings.
Configuring a Point-to-Multi-Point Wireless Bridge
To configure a point-to-multi-point wireless bridge as shown in Figure 5-7:
1. Under the Configuration tab, select Wireless Bridge. Then, select Bridging. The Bridging
screen displays.
2. Configure the Operating Mode of the WN604 Wireless Access Points.
• WN604 (AP1) on LAN Segment 1 in Point-to-Point Bridge mode with the Remote MAC
Address of AP2.
• Because it is in the central location, configure WN604 (AP2) on LAN Segment 2 in Point-
to-Multi-Point Bridge mode. The MAC addresses of the adjacent APs are required in AP2.
• Configure the WN604 (AP3) on LAN 3 in Point-to-Point Bridge mode with the Remote
MAC Address of AP2.
3. Verify the following parameters for all access points:
• Verify that the LAN network configuration the WN604 Wireless Access Points are
configured to operate in the same LAN network address range as the LAN devices
Figure 5-7 Wireless point-to-multipoint bridge setup
'Master' AP in
Point-to-Multi-Point
Bridge Mode
LAN
Segment 1
192.168.0.1
Router
AP in
Point-to-Point
Bridge Mode
Hub or Switch
LAN
Segment 3
AP in
Point-to-Point
Bridge Mode
LAN
Segment 2
Hub or Switch
AP1
ETHERNET
RESET
5-12V DC
AP3
ETHERNET
RESET
5-12V DC
AP2
ETHERNET
RESET
5-12V DC