User's Manual
Table Of Contents
- NETGEAR Wireless N150 Access Point WN604 Reference Manual
- Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Basic Installation and Configuration
- Chapter 3
- Understanding Security Profiles
- Wi-Fi Protected Setup (WPS)
- Configuring Security Manually
- SSID and WEP/WPA Settings Setup Form
- Configuring the RADIUS Server Settings
- Setting up a Security Profile
- Configuring WEP
- Configuring WPA with RADIUS
- Configuring WPA2 with RADIUS
- Configuring WPA and WPA2 with RADIUS
- Configuring WPA-PSK
- Configuring WPA2-PSK
- Configuring WPA-PSK and WPA2-PSK
- Restricting Wireless Access by MAC Address
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting and Debugging
- No lights are lit on the wireless access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WN604 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
5-1
v1.0, March 2010
Chapter 5
Advanced Configuration
This chapter describes how to configure the advanced features of your NETGEAR Wireless N150
Access Point WN604. The advanced configuration features are located under various sub-menus
under Configuration and provide the following functions:
• Scheduled Wireless: Configuring Scheduled Wireless ON/OFF parameters (“Configuring
Scheduled Wireless”)
• Wireless Settings: Configuring advanced wireless LAN parameters (“Configuring Advanced
Wireless Settings”).
• Advanced QoS Settings: Configuring advanced QoS settings (“Configuring Advanced QoS
Settings”)
• Access Point Settings: Enabling wireless bridge and repeater modes (“Enabling Wireless
Bridging”).
Configuring Scheduled Wireless
The WN604 Wireless Access Point allows you to schedule wireless ON/OFF for any day(s) of the
week, from an ON time to an OFF time. Click Configuration > Wireless > Scheduled Wireless
ON-OFF.
This feature depends on the NTP (Network Time Protocol) functionality. If an NTP client request
fails, then last configured value of radio status by user will be restored. Also, if RF is disabled then
scheduled wireless functionality will not work.