User's Manual
Table Of Contents
- NETGEAR Wireless N150 Access Point WN604 Reference Manual
- Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Basic Installation and Configuration
- Chapter 3
- Understanding Security Profiles
- Wi-Fi Protected Setup (WPS)
- Configuring Security Manually
- SSID and WEP/WPA Settings Setup Form
- Configuring the RADIUS Server Settings
- Setting up a Security Profile
- Configuring WEP
- Configuring WPA with RADIUS
- Configuring WPA2 with RADIUS
- Configuring WPA and WPA2 with RADIUS
- Configuring WPA-PSK
- Configuring WPA2-PSK
- Configuring WPA-PSK and WPA2-PSK
- Restricting Wireless Access by MAC Address
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting and Debugging
- No lights are lit on the wireless access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WN604 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless N150 Access Point WN604 Reference Manual
3-12
v1.0, March 2010
To configure a Security Profile:
1. From your Web browser, log in to the WN604 using the default LAN address of
http://192.168.0.100, user name admin and password password, or use the LAN address and
password that you set up.
2. Under the Configuration tab, select
Security from the main menu. The screen for the Edit
Security Profile displays as shown in Figure 3-8above.
3. Enter the Wireless Network Name (SSID) to identify the wireless network. It is set by default
to NETGEAR_11ng.
4. Enable or disable the Broadcast Wireless Network Name (SSID). It is enabled by default. (If
it is broadcast, it can be easily detected by other clients.)
5. From the Network Authentication pull-down menu, select the Network Authentication Type
you want to use for this profile:
• To configure WEP encryption for Open Systems or Shared Key, see “Configuring WEP”
on page 3-12.
• To configure WPA with RADIUS, see “Configuring WPA with RADIUS” on page 3-14.
• To configure WPA2 with RADIUS, see “Configuring WPA2 with RADIUS” on
page 3-16.
• To configure WPA and WPA2 with RADIUS, see “Configuring WPA and WPA2 with
RADIUS” on page 3-17.
• To configure WPA-PSK, see “Configuring WPA-PSK” on page 3-19.
• To configure WPA2-PSK, see “Configuring WPA2-PSK” on page 3-20.
• To configure WPA-PSK and WPA2-PSK, see “Configuring WPA-PSK and WPA2-PSK”
on page 3-20.
6. Data Encryption: Select data encryption strength from the pull down menu.
7. Wireless Client Security Separation is disabled by default. If enabled, the associated
wireless clients will not be able to communicate with each other.
8. Click Apply to save your Security Profile settings.
Configuring WEP
To configure WEP data encryption:
1. From the Network Authentication drop-down menu, choose either Open System or Shared
Key authentication.