User's Manual
Table Of Contents
- NETGEAR Wireless N150 Access Point WN604 Reference Manual
- Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Basic Installation and Configuration
- Chapter 3
- Understanding Security Profiles
- Wi-Fi Protected Setup (WPS)
- Configuring Security Manually
- SSID and WEP/WPA Settings Setup Form
- Configuring the RADIUS Server Settings
- Setting up a Security Profile
- Configuring WEP
- Configuring WPA with RADIUS
- Configuring WPA2 with RADIUS
- Configuring WPA and WPA2 with RADIUS
- Configuring WPA-PSK
- Configuring WPA2-PSK
- Configuring WPA-PSK and WPA2-PSK
- Restricting Wireless Access by MAC Address
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting and Debugging
- No lights are lit on the wireless access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WN604 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless N150 Access Point WN604 Reference Manual
Basic Installation and Configuration 2-11
v1.0, March 2010
Logging In Using the Default IP Address
After you install the WN604, log in to the wireless access point to configure the basic settings and
the wireless settings. The WN604 is set, by default, with the IP address of 192.168.0.100 with
DHCP disabled.
To log in using the default IP Address:
1. Open a Web browser such as Internet Explorer or Mozilla Firefox.
2. Connect to the WN604 by entering its default address of http://192.168.0.100 into your
browser. The login screen displays. Enter admin for the user name and password for the
password, both in lower case letters.
3. Click Login.
Your Web browser should automatically find the WN604 Wireless Access Point and display
the home screen.
Note: The computer you are using to connect to the WN604 should be configured with
an IP address that starts with 192.168.0.x and a Subnet Mask of 255.255.255.0.
Figure 2-7 Connecting to the Access Point