User's Manual
Table Of Contents
- NETGEAR Wireless N150 Access Point WN604 Reference Manual
- Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Basic Installation and Configuration
- Chapter 3
- Understanding Security Profiles
- Wi-Fi Protected Setup (WPS)
- Configuring Security Manually
- SSID and WEP/WPA Settings Setup Form
- Configuring the RADIUS Server Settings
- Setting up a Security Profile
- Configuring WEP
- Configuring WPA with RADIUS
- Configuring WPA2 with RADIUS
- Configuring WPA and WPA2 with RADIUS
- Configuring WPA-PSK
- Configuring WPA2-PSK
- Configuring WPA-PSK and WPA2-PSK
- Restricting Wireless Access by MAC Address
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting and Debugging
- No lights are lit on the wireless access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WN604 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless N150 Access Point WN604 Reference Manual
2-8 Basic Installation and Configuration
v1.0, March 2010
2. Configure the following information:
– Time Zone. From the pull-down menu, select the local time zone for your wireless access
point from a list of all available time zones. The default is USA-Pacific.
– NTP Client. Enable NTP Client to synchronize the time of the access point with an NTP
Server. The Default is Enabled.
– Use Custom NTP Server. Check the option if you have a custom NTP server. The default
is Disabled.
– Hostname / IP Address. Enter the host name or the IP address of the custom NTP server.
The default is time-b.netgear.com.
3. Click Apply.
Figure 2-5 Timezone and system time related settings
Note: You must have an Internet connection to get the current time.