User's Manual
Table Of Contents
- NETGEAR Wireless N150 Access Point WN604 Reference Manual
- Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Basic Installation and Configuration
- Chapter 3
- Understanding Security Profiles
- Wi-Fi Protected Setup (WPS)
- Configuring Security Manually
- SSID and WEP/WPA Settings Setup Form
- Configuring the RADIUS Server Settings
- Setting up a Security Profile
- Configuring WEP
- Configuring WPA with RADIUS
- Configuring WPA2 with RADIUS
- Configuring WPA and WPA2 with RADIUS
- Configuring WPA-PSK
- Configuring WPA2-PSK
- Configuring WPA-PSK and WPA2-PSK
- Restricting Wireless Access by MAC Address
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting and Debugging
- No lights are lit on the wireless access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WN604 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless N150 Access Point WN604 Reference Manual
Introduction 1-9
v1.0, March 2010
Side Panel
The WN604 side panel hardware functions are described below.
1. Wireless ON/OFF switch.
Use this switch to enable or disable the radio (see “Configuring 802.11b/bg/ng Wireless
Settings” on page 2-13).
2. WPS Push Button.
Use this push button to automatically configure security settings on the WN604 (see
“Configuring a client using WPS” on page 3-5).
Figure 1-3 WN604 Side Panel