User's Manual
Table Of Contents
- NETGEAR Wireless N150 Access Point WN604 Reference Manual
- Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Basic Installation and Configuration
- Chapter 3
- Understanding Security Profiles
- Wi-Fi Protected Setup (WPS)
- Configuring Security Manually
- SSID and WEP/WPA Settings Setup Form
- Configuring the RADIUS Server Settings
- Setting up a Security Profile
- Configuring WEP
- Configuring WPA with RADIUS
- Configuring WPA2 with RADIUS
- Configuring WPA and WPA2 with RADIUS
- Configuring WPA-PSK
- Configuring WPA2-PSK
- Configuring WPA-PSK and WPA2-PSK
- Restricting Wireless Access by MAC Address
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting and Debugging
- No lights are lit on the wireless access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WN604 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless N150 Access Point WN604 Reference Manual
1-8 Introduction
v1.0, March 2010
Rear Panel
The WN604 rear panel functions are described below:
1. Power Socket
This socket connects to the WN604 12V 1A power adapter.
2. Power ON/OFF switch.
3. 4 x 10/100 RJ-45 Ethernet Ports
Use the WN604 Ethernet RJ-45 port to connect to an Ethernet LAN through a device such as a
hub, switch, router, or PoE switch.
4. Restore to Factory Defaults Button
The restore to default button located between the Ethernet RJ-45 connector and the antenna
restores the WN604 to the factory default settings.
1. Fixed rear Antenna
The WN604 provides a single fixed antenna on the rear panel.
Figure 1-2 WN604 Rear Panel