User's Manual
Table Of Contents
- NETGEAR Wireless N150 Access Point WN604 Reference Manual
- Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Basic Installation and Configuration
- Chapter 3
- Understanding Security Profiles
- Wi-Fi Protected Setup (WPS)
- Configuring Security Manually
- SSID and WEP/WPA Settings Setup Form
- Configuring the RADIUS Server Settings
- Setting up a Security Profile
- Configuring WEP
- Configuring WPA with RADIUS
- Configuring WPA2 with RADIUS
- Configuring WPA and WPA2 with RADIUS
- Configuring WPA-PSK
- Configuring WPA2-PSK
- Configuring WPA-PSK and WPA2-PSK
- Restricting Wireless Access by MAC Address
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting and Debugging
- No lights are lit on the wireless access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WN604 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless N150 Access Point WN604 Reference Manual
A-2 Default Settings and Technical Specifications
v1.0, March 2010
Time Zone USA-Pacific
Wireless
Operating Mode Access Point
Access Point Name
netgearxxxxxx where xxxxxx are the last 6 digits of the
wireless access point “Ethernet” MAC address.
Wireless Communication Enabled
Wi-Fi Protected Setup (WPS) Disabled
11 b/bg/ng Wireless Network Name
(SSID)
NETGEAR_11ng
Broadcast Network Name SSID Enabled
Security Disabled
Transmission Speed Best
a
Country/Region Varies by region
Scheduled Wireless ON/OFF Disabled
80211.b/bg/ng Radio Frequency Channel Auto
Output Power
Full
Wireless Card Access List All wireless stations allowed
WMM Support Enabled
a. Maximum Wireless signal rate derived from IEEE Standard 802.11 specifications. Actual throughput will vary.
Network conditions and environmental factors, including volume of network traffic, building materials and
construction, and network overhead, lower actual data throughput rate.
Table A-1. Access Point Default Configuration Settings
Feature Description