User's Manual

XAVN2001 Powerline AV 200 Wireless-N Extender User Manual
Troubleshooting B-3
v1.0, July 2010
Problems After Changing Network Encryption Key
.If your Powerline devices stop communicating after you have used the NETGEAR XAVN2001
Powerline Utility, you’ll need to change the network encryption key.
To change the network encryption key:
1. Open the XAVN2001 NETGEAR Powerline Utility and select the Security option on the
Advanced tab.
2. Select the device.
For each remote device, enter its password (printed on the product label), and then select it.
3. Click the Use Default Encryption Key button.
4. Click the Apply Security to Selected Devices button.
5. Select the Device Settings tab, and check that the utility detects all the Powerline AV 200
Wireless-N Extenders in your Powerline network.
If the utility detects all your Powerline devices, you can specify a new network encryption key
as described in “Adding a Device to a Powerline Network” in Chapter 2.
If the utility does not detect them all, see the following section, “Changing the Network
Encryption Key for One Unit at a Time”.
Figure B-1