User's Manual

Wireless-N 300 Modem Router DGN2200 User Manual
Wall Mounting and Technical Specifications A-4
v1.0, November 2009
Factory Default Configuration
You can use the Wireless On/Off and WPS buttons on the side panel of your router to restore
factory default settings. This is called a hard reset. To perform a hard reset, push and hold the
Wireless On/Off and WPS buttons simultaneously for 6 seconds. Your router will return to the
factory configuration settings shown in the following table..
Regulatory compliance FCC Part 15 Class B; VCCI Class B; EN 55 022 (CISPR 22), Class B
Network protocol and
standards compatibility
TCP/IP, RIP-1, RIP-2, DHCP, PPPoE or PPPoA, RFC 1483 Bridged or
Routed Ethernet, and RFC 1577 Classical IP over ATM
Power adapter North America: 120V, 60 Hz, input
Regulatory compliance FCC Part 15 Class B; VCCI Class B; EN 55 022 (CISPR 22), Class B
Interface specifications LAN: 10BASE-T or 100BASE-Tx, RJ-45
WAN: ADSL, Dual RJ-11, pins 2 and 3
T1.413, G.DMT, G.Lite
ITU Annex A or B
ITU G.992.5 (ADSL2+)
Table A-2. Factory Default Settings
Feature Default Behavior
Router Login User login URL http://www.routerlogin.com
User name (case-sensitive) admin
Login password (case-sensitive) password
Internet
connection
WAN MAC address Use default address
WAN MTU size 1500
Port speed Autosensing
Local network
(LAN)
LAN IP 192.168.0.1
Subnet mask 255.255.255.0
RIP direction None
RIP version Disabled
RIP authentication None
DHCP server Enabled
Table A-1. General Specifications (continued)
Specification Description