User's Manual
Table Of Contents
- ProSafe Dual Band Wireless N Access Point WNDAP350 Reference Manual
- Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Basic Installation and Configuration
- Wireless Equipment Placement and Range Guidelines
- Understanding WNDAP350 Wireless Security Options
- Installing the WNDAP350 wirelss access point
- Logging In Using the Default IP Address
- Setting Basic IP Options
- Wireless Settings
- Setting Up and Testing Basic Wireless Connectivity
- Understanding Security Profiles
- SSID and WEP/WPA Settings Setup Form
- Configuring the RADIUS Server Settings
- Setting up a Security Profile
- Configuring WEP
- Configuring WPA with RADIUS
- Configuring WPA2 with RADIUS
- Configuring WPA and WPA2 with RADIUS
- Configuring WPA-PSK
- Configuring WPA2-PSK
- Configuring WPA-PSK and WPA2-PSK
- Restricting Wireless Access by MAC Address
- Chapter 3 Management
- Remote Management
- Remote Console
- Upgrading the Wireless Access Point Software
- Configuration File Management
- Changing the Administrator Password
- Enabling the SysLog Server
- Using Activity Log Information
- Viewing General Summary Information
- Viewing Network Traffic Statistics
- Viewing Available Wireless Station Statistics
- Enabling Rogue AP Detection
- Viewing Rogue AP Statistics
- Packet Capture
- Chapter 4 Advanced Configuration
- Chapter 5 Troubleshooting and Debugging
- No lights are lit on the wireless access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WNDAP350 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Appendix C 2.0 Command Line Reference
- Index
4-1
v2.0, April 2013
Chapter 4
Advanced Configuration
This chapter describes how to configure the advanced features of your ProSafe Dual Band
Wireless N Access Point WNDAP350 . The advanced configuration features are located under
various sub-menus under Configuration and provide the following functions:
• IP Settings. Using the wireless access point as a DHCP server for wireless clients (“IP
Settings for Wireless Clients).
• Hotspot settings. Enabling HTTP redirect (“Hotspot Settings).
• Wireless Settings: Configuring advanced wireless LAN parameters (“Configuring Advanced
Wireless Settings).
• Advanced QoS Settings: Configuring advanced QoS settings (“Configuring Advanced QoS
Settings)
• Access Point Settings: Enabling wireless bridge modes (“Enabling Wireless Bridging).
IP Settings for Wireless Clients
You can turn the WNDAP350 into a DHCP Server for wireless clients for both DHCP-enabled
wireless clients. The default advanced IP wireless settings usually work well. This feature is
intended for use by a systems administrator. By default, this feature is not enabled.
To use this wireless access point as a DHCP server:
1. From the main menu under Configuration, select IP, and then select DHCP Server Settings.
The DHCP Server Settings screen displays (see Figure 4-1).
2. DHCP Server is disabled by default. Select the Enable radio button to enable this wireless
access point as a DHCP server.