User's Manual
Table Of Contents
- ProSafe Dual Band Wireless N Access Point WNDAP350 Reference Manual
- Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Basic Installation and Configuration
- Wireless Equipment Placement and Range Guidelines
- Understanding WNDAP350 Wireless Security Options
- Installing the WNDAP350 wirelss access point
- Logging In Using the Default IP Address
- Setting Basic IP Options
- Wireless Settings
- Setting Up and Testing Basic Wireless Connectivity
- Understanding Security Profiles
- SSID and WEP/WPA Settings Setup Form
- Configuring the RADIUS Server Settings
- Setting up a Security Profile
- Configuring WEP
- Configuring WPA with RADIUS
- Configuring WPA2 with RADIUS
- Configuring WPA and WPA2 with RADIUS
- Configuring WPA-PSK
- Configuring WPA2-PSK
- Configuring WPA-PSK and WPA2-PSK
- Restricting Wireless Access by MAC Address
- Chapter 3 Management
- Remote Management
- Remote Console
- Upgrading the Wireless Access Point Software
- Configuration File Management
- Changing the Administrator Password
- Enabling the SysLog Server
- Using Activity Log Information
- Viewing General Summary Information
- Viewing Network Traffic Statistics
- Viewing Available Wireless Station Statistics
- Enabling Rogue AP Detection
- Viewing Rogue AP Statistics
- Packet Capture
- Chapter 4 Advanced Configuration
- Chapter 5 Troubleshooting and Debugging
- No lights are lit on the wireless access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WNDAP350 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Appendix C 2.0 Command Line Reference
- Index
ProSafe Dual Band Wireless N Access Point WNDAP350 Reference Manual
A-2 Default Settings and Technical Specifications
v2.0, April 2013
DHCP Client Disabled
Time Zone USA-Pacific
Time Zone Adjusted for Daylight Saving
Time
Disabled
SNMP Enabled, but Trap forwarding disabled
Spanning Tree Protocol Disabled
Secure Telnet Enabled
Wireless
Operating Mode Access Point
Access Point Name
netgearxxxxxx where xxxxxx are the last 6 digits of the
wireless access point MAC address.
Wireless Communication Enabled
11a/na Wireless Network Name (SSID) NETGEAR_11a
11 b/bg/ng Wireless Network Name
(SSID)
NETGEAR_11g
Broadcast Network Name SSID Enabled
Security Disabled
Transmission Speed Best
a
Country/Region Varies by region
80211.a Radio Frequency Channel Auto
80211.g Radio Frequency Channel Auto
Output Power
Full
Wireless Card Access List All wireless stations allowed
WMM Support Enabled
a. Maximum Wireless signal rate derived from IEEE Standard 802.11 specifications. Actual throughput will vary.
Network conditions and environmental factors, including volume of network traffic, building materials and
construction, and network overhead, lower actual data throughput rate.
Table A-1. Access Point Default Configuration Settings
Feature Description