User Manual
Table Of Contents
- RangeMax Wireless-N Gigabit Router DSL Modem Setup Manual
- Contents
- Getting to Know Your Wireless Router
- Installing Your Router Using the Smart Wizard
- Installing Your Router Manually (Advanced, Mac, and Linux Users)
- Configuring Your Wireless Network
- Troubleshooting
- Technical Specifications
- Related Documents
- Registration and Certifications
40 Technical Specifications
Default Configuration
You can use the Wireless On/Off button and the WPS Dome on top of your router to reset all
settings to their factory defaults. This is called a hard reset. To perform a hard reset, push and hold
the Wireless On/Off button and WPS Dome simultaneously for 6 seconds. Your router will return
to the factory configuration settings that are shown in the table below. NOTE TO REVIEWERS:
IS THIS THE FAVORED METHOD FOR FACTORY RESET?
Interface Specifications
LAN: 10BASE-T or 100BASE-Tx, RJ-45
WAN: ADSL, Dual RJ-11, pins 2 and 3
T1.413, G.DMT, G.Lite
Feature Default Behavior
Router Login
User Login URL http://www.routerlogin.net or http://www.routerlogin.com
User Name (case sensitive) admin
Login Password (case sensitive) password
Internet Connection
WAN MAC Address Use Default address
WAN MTU Size 1500
Port Speed AutoSense
Local Network (LAN)
Lan IP 192.168.0.1
Subnet Mask 255.255.255.0
RIP Direction None
RIP Version Disabled
RIP Authentication None
DHCP Server Enabled
DHCP Starting IP Address 192.168.0.2
DHCP Ending IP Address 192.168.0.254
DMZ Disabled
Time Zone GMT