User's Manual
Table Of Contents
- NETGEAR Wireless-N 300 Router WNR2000v2 User Manual
- Contents
- Chapter 1 Configuring Basic Connectivity
- Chapter 2 Safeguarding Your Network
- Choosing Appropriate Wireless Security
- Recording Basic Wireless Settings Setup Information
- Changing Wireless Security Settings
- Viewing Advanced Wireless Settings
- Using Push 'N' Connect (Wi-Fi Protected Setup)
- Restricting Wireless Access by MAC Address
- Changing the Administrator Password
- Backing Up Your Configuration
- Understanding Your Firewall
- Chapter 3 Restricting Access From Your Network
- Chapter 4 Customizing Your Network Settings
- Chapter 5 Fine-Tuning Your Network
- Chapter 6 Using Network Monitoring Tools
- Chapter 7 Troubleshooting
- Appendix A Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless-N 300 Router WNR2000v2 User Manual
1-10 Configuring Basic Connectivity
v1.0, September 2009
• Telstra Bigpond, an Australian residential cable modem service
• Other, which selects PPPoE (Point to Point Protocol over Ethernet), the protocol used
by most DSL services worldwide.
– Login and Password. This is the user name and password provided by your ISP. This
name and password are used to log in to the ISP server.
– Service Name. If your connection is capable of connecting to multiple Internet services,
this setting specifies which service to use.
• Connection Mode. This drop-down list selects when the router will connect to and
disconnect from the Internet.
Note: The Telstra Bigpond setting is only for older cable modem service
accounts still requiring a Bigpond login utility. Telstra has
discontinued this type of account. Those with Telstra DSL accounts
and newer cable modem accounts should select No for Does Your
Internet Connection Require a Login.
Figure 1-8
Note: Not all ISPs are listed here. The ones on this list have special
requirements.
Figure 1-9