User Manual
Table Of Contents
- NETGEAR WNAP210 ProSafe Wireless-N Access Point Reference Manual
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
ProSafe Wireless-N Access Point WNAP210 Reference Manual
A-2 Default Settings and Technical Specifications
v1.0, February 2009
Lan IP 192.168.0.236
Subnet Mask 255.255.255.0
Gateway Address 192.168.0.1
DHCP Client Disabled
Time Zone GMT-08:00
Time Zone Adjusted for Daylight Saving
Time
Disabled
Wireless
Operating Mode 11b/g/Next (20/40 MHz)
Wireless Communication Enabled
Wireless Network Name (SSID) NETGEAR
Broadcast Network Name SSID Enabled
Security Disabled
Transmission Speed Auto
a
Country/Region United States (in North America; otherwise, varies by
region)
Channel/Radio Frequency 6/2.43 GHz (until the region is selected)
Output Power
Full
Wireless Card Access List All wireless stations allowed
a. Maximum Wireless signal rate derived from IEEE Standard 802.11 specifications. Actual throughput will vary.
Network conditions and environmental factors, including volume of network traffic, building materials and
construction, and network overhead, lower actual data throughput rate.
Table A-1. Access Point Default Configuration Settings
Feature Description