User Manual
Table Of Contents
- NETGEAR WNAP210 ProSafe Wireless-N Access Point Reference Manual
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
ProSafe Wireless-N Access Point WNAP210 Reference Manual
6-4 Troubleshooting
v1.0, February 2009
• Reset to Factory Defaults: This button can also be used to clear ALL data and restore ALL
settings to the factory default values. These settings are shown in
Appendix A, “Default
Settings and Technical Specifications”.
To clear all data and restore the factory default values:
1. Power off the WNAP210 and power it back on.
2. Use something with a small point, such as a pen, to press the reset button in and hold it in for
at least five seconds—or until the power light changes from blinking green to amber.
3. Release the reset button.
The factory default configuration has now been restored, and the WNAP210 is ready for use.