User Manual
Table Of Contents
- NETGEAR WNAP210 ProSafe Wireless-N Access Point Reference Manual
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
ProSafe Wireless-N Access Point WNAP210 Reference Manual
Advanced Wireless Bridging 5-5
v1.0, February 2009
To configure the WNAP210 in wireless repeater mode:
1. Open a
web browser and log into the WNAP210 using the addressing scheme you have set up.
Figure 5-3
2. Under Advanced on the main menu, click Wireless Bridging. The Wireless Bridging screen
will display showing the default settings for the wireless access point.
3. Select the Repe
ater with Wireless Client Association radio button to enable Repeater Mode.
4. Enter the MAC addres
s of the remote wireless access point and click Add. The AP’s MAC
address and connection information will appear in the Wireless Remote Access Point List.
5. Click Ap
ply to save your changes.