User Manual
Table Of Contents
- NETGEAR WNAP210 ProSafe Wireless-N Access Point Reference Manual
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
ProSafe Wireless-N Access Point WNAP210 Reference Manual
5-2 Advanced Wireless Bridging
v1.0, February 2009
.
Figure 5-1
2. Under Advanced on the main menu, click Wireless Bridging. The Advanced Wireless
Bridging screen will display showing the default settings for the wireless access point.
3. Select the W
ireless Multi-Point Bridging radio button to enable multi-point bridging.
4. Enter the MAC addres
s of the first wireless access point and click Add. The AP’s MAC
address and connection information will appear in the Wireless Accept Point List.
You can add wireless access points to the list for a
total of six. (These wireless access points
must be configured for Multi-Point Bridging.)
5. Check the Enable W
ireless Client Association radio box to allow wireless clients access to
this wireless access point.
6. Click Ap
ply to save your changes.
To delete a remote AP from the list, click Dele
te adjacent to the AP’s MAC address in the
Wireless Remote Access Point List.