User Manual
Table Of Contents
- NETGEAR WNAP210 ProSafe Wireless-N Access Point Reference Manual
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
ProSafe Wireless-N Access Point WNAP210 Reference Manual
4-6 Management
v1.0, February 2009
2. Click Refresh to update the list and force the wireless access point to look for associated
devices.
Figure 4-6
• For each device, the table shows the Station ID, MAC address, IP Address, and Status
(whether the device is allowed to communicate with the wireless access point or not).
• If the wireless access point is rebooted, the table da
ta is lost until the wireless access point
rediscovers the devices.
Note: A wireless network can include multiple wireless access points, all using the
same network name (SSID). This extends the reach of the wireless network
and lets users roam from one access point to another which provides seamless
network connectivity. Under these circumstances, be aware that only the
stations associated with this wireless access point will be presented in the
Available Wireless Station List.
Viewing the Statistics
The Statics screen displays both wired and wireless interface network traffic.
To display statics for the wireless access point:
1. Select St
atistics under the Information menu on the left information pane. The Statistics
screen will display.