User Manual
Table Of Contents
- NETGEAR WNAP210 ProSafe Wireless-N Access Point Reference Manual
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
Figure 4-3
ProSafe Wireless-N Access Point WNAP210 Reference Manual
Management 4-3
v1.0, February 2009
4. Click Browse and go to the location of the downloaded software upgrade file.
5. Click Up
load.
Warning: When uploading firmware to the wireless access point, it is important not
to interrupt the Web browser by closing the window, clicking a link, or
loading a new page. If the browser is interrupted, the upload may fail,
corrupt the software, and render the WNAP210 inoperable.
In some cases, it may be necessary to reconfigure the wireles
s access point after upgrading.
Backing Up or Restoring Settings
You can back up your configuration settings of the ProSafe Access Point and restore the factory
default settings. Once you have your wireless access point working properly, backing up the
configured settings would be prudent should you have to perform a factory reset. When you
backup the settings, they are saved as a file on your computer that you can access to restore the
wireless access point’s configured settings.
To backup/restore settings:
1. From
the main menu of the browser interface, select Backup/Restore Settings from under the
Management menu. The Backup/Restore Settings screen will display.