User Manual
Table Of Contents
- NETGEAR WNAP210 ProSafe Wireless-N Access Point Reference Manual
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
ProSafe Wireless-N Access Point WNAP210 Reference Manual
4-2 Management
v1.0, February 2009
2. First enter the old password, in the Old Password field.
3. The
n enter the new password twice in the New Password and Repeat New Password fields.
4. Click Ap
ply to save your changes.
Note: Be sure to write down the new password and store it in a safe place.
To restore the default password:
1. Check the Restor
e Default Password radio button.
2. Click Ap
ply. The default password will be restored.
Upgrading the Wireless Access Point Firmware
The software of the ProSafe Access Point is stored in FLASH memory, and can be upgraded as
new software is released by NETGEAR. Upgrade files can be downloaded from the NETGEAR
Web site. If the upgrade file is compressed (.ZIP file), you must first extract the image (.img) file
before sending it to the wireless access point. The upgrade file can be sent using your browser.
Note: The Web browser used to upload new firmware into the ProSafe Access Point must
support HTTP uploads, such as Microsoft Internet Explorer 6.0 or above, or
Netscape Navigator 4.78 or above.
To upgrade the firmware:
1. Go
to the NETGEAR Web site at http://kbserver.netgear.com/downloads_support.asp to get
new versions of the Access Point software.
2. Down
load, save and unzip (if the download file is a .zip file) the new software file.
3. From
the main menu of the browser interface, click Upgrade Firmware under the
Management menu on the left navigation panel. The Upgrade Firmware screen will display.