User Manual
Table Of Contents
- NETGEAR WNAP210 ProSafe Wireless-N Access Point Reference Manual
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
4-1
v1.0, February 2009
Chapter 4
Management
This chapter describes how to use the management and information features as well as the
advanced wireless settings features of your ProSafe Wireless-N Access Point. These features can
be found under the Management, Information and Advanced menus on the left navigation pane of
the browser interface.
Changing the Password
Note: Before changing the WNAP210 password, use the backup utility to save your
configuration settings. If you forget your new password, you must reset the
WNAP210 back to the factory defaults and use the default password.
Consequently, you will have to restore any WNAP210 configuration settings you
have made. The backup file can be used in this event.
The default password for the WNAP210 is
password. NETGEAR recommends that you change
this password to a more secure password.
To change the password:
1. Select Chan
ge Password under the Management menu on the left navigation pane. The
Change Password screen will display.
Figure 4-1
Figure 4-2