User Manual
Table Of Contents
- NETGEAR WNAP210 ProSafe Wireless-N Access Point Reference Manual
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
ProSafe Wireless-N Access Point WNAP210 Reference Manual
Wireless Security Settings 3-11
v1.0, February 2009
5. The Trusted Wireless Stations table will display any wireless stations you have entered. If
you have not entered any wireless stations this list will be empty.
Note: If Turn Access Control On is enabled and the Access Control List is blank,
then no wireless PCs will be able to connect to your wireless network
To delete an existing entry:
Check the radio button adjacent to the entry and then click Delete.
To set up the trusted wireless stations control list:
1. Click Ad
d on the Access Control List screen. The Wireless Card Access Setup screen will
display. The Available Wireless Cards table will display all available wireless PCs and their
MAC addresses.
Figure 3-9
2. If the wireless PC you want to add appears in the list, check its adjacent radio button and click
Add.
• If the PC is not displayed, make sure that it
is configured correctly and click Refresh.
• If no wireless PCs appear in the A
vailable Wireless Cards access list, then you can
manually enter the Device Name and MAC Address of the wireless PC in the appropriate
fields and then click Add. (You can usually find the MAC address printed on the bottom
of the wireless adapter.)