User Manual
Table Of Contents
- NETGEAR WNAP210 ProSafe Wireless-N Access Point Reference Manual
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
Figure 3-6
ProSafe Wireless-N Access Point WNAP210 Reference Manual
Wireless Security Settings 3-9
v1.0, February 2009
2. Select one of the following radio buttons: WPA with Radius, WPA2 with Radius, or WPA +
WPA2 with Radius. Your selection will display.
Figure 3-7
3. Click Apply to save your settings. A message appears informing you that you must configure
the Radius Server Settings menu.
4. Click OK.
5. Configure
the Radius Server Settings menu using the procedure described in “Configuring the
RADIUS Server Settings” on page 4-9.