User Manual
Table Of Contents
- NETGEAR WNAP210 ProSafe Wireless-N Access Point Reference Manual
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
Figure 3-5
ProSafe Wireless-N Access Point WNAP210 Reference Manual
3-8 Wireless Security Settings
v1.0, February 2009
3. Enter the preshared key Passphrase (Network Key).
4. Click Ap
ply to save your settings.
Configuring WPA with Radius, WPA2 with Radius, and WPA
+ WPA2 with Radius
In an organization with many wireless users, using a single preshared key may not be a practical
security method. Deploying a RADIUS server will allow you to manage user authentication
individually and centrally.
To configure WPA with Radius, WPA2 with Radius, or WPA + WPA2 with Radius:
1. Select WEP/WP
A Settings under the Security menu on the left navigation pane. The WEP/
WPA Settings screen will display.