User Manual
Table Of Contents
- NETGEAR WNAP210 ProSafe Wireless-N Access Point Reference Manual
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
Figure 3-3
ProSafe Wireless-N Access Point WNAP210 Reference Manual
3-6 Wireless Security Settings
v1.0, February 2009
5. Select the key to be used as the default key by checking the radio box. (Data transmissions are
always encrypted using the default key.)
See the document “Wireless Communications”
for a full explanation of each of these options,
as defined by the IEEE 802.11 wireless communication standard. A link to this document on
the NETGEAR website is in Appendix B, “Related Documents.”
6. Click Ap
ply to save your settings.
Note: If you use a wireless computer to configure WEP settings, you will be
disconnected when you click Apply. Reconfigure your wireless adapter to match
the new settings or access the wireless access point from a wired computer to
make any further changes.