User Manual
Table Of Contents
- NETGEAR WNAP210 ProSafe Wireless-N Access Point Reference Manual
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
Step 1
Step 2
Step 3
Figure 2-5
ProSafe Wireless-N Access Point WNAP210 Reference Manual
Installation and Configuration 2-11
v1.0, February 2009
Configuring and Testing Your PCs for Wireless Connectivity
Program the wireless adapter of your PCs to have the same SSID and channel that you configured
in Wireless Settings for the WNAP210. Check that they have a wireless link and are able to obtain
an IP address by DHCP from the WNAP210.
Note: If you are configuring the WNAP210 from a wireless computer and you change the
SSID, channel, or Security Profile settings, you will lose your wireless connection
when you click Apply. You must then change the wireless settings of your
computer to match the new settings.
Once your PCs have basic wireless connectivity to the WNAP210, you can deploy the WNAP210
an
d configure the advanced wireless security functions.