User Manual
Table Of Contents
- NETGEAR WNAP210 ProSafe Wireless-N Access Point Reference Manual
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
ProSafe Wireless-N Access Point WNAP210 Reference Manual
2-8 Installation and Configuration
v1.0, February 2009
.
Figure 2-4
2. From the Country/Region pull-down menu, select the region where the WNAP210 can be
used (the Country/Region is not Configurable in the United States; but is configurable in the
rest of the world).
Note: If your country or region is not listed, please check with your local government
agency.
3. Configure the W
ireless LAN settings based on the following field descriptions:
• Tu
rn Radio On. On by default, you can also turn off the radio to disable access through
this device. This can be helpful for configuration, network tuning, or troubleshooting
activities.
• W
ireless Network Name (SSID). Enter a 32-character (maximum) service set ID in this
field; the characters are case sensitive. When the wireless access point is deployed in
“infrastructure” mode, the SSID assigned to a wireless device must match the wireless
access point SSID in order for the wireless device to communicate with the WNAP210. If
they do not match, you will not get a wireless connection to the WNAP210. The default is
NETGEAR.
• Br
oadcast Wireless Network Name (SSID). If Enabled, the Wireless Access Point
broadcasts its SSID allowing Wireless Stations which have a “null” (blank) SSID to adopt
the correct SSID. If set to disable, the SSID is not broadcast. The default is Enabled.
• W
ireless Mode. From the pull-down menu, select the desired wireless operating mode:
–
11b/g – Both 802.11b and 802.11g wireless stations can be used.