User Manual
Table Of Contents
- NETGEAR WNAP210 ProSafe Wireless-N Access Point Reference Manual
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
ProSafe Wireless-N Access Point WNAP210 Reference Manual
Installation and Configuration 2-7
v1.0, February 2009
– Default Gateway. Enter the IP address of the gateway for your LAN. For more complex
networks, enter the address of the router for the network segment to which the wireless
access point is connected. The default is 0.0.0.0.
– Primary DNS Se
rvers. The WNAP210 will use this IP address as the primary Domain
Name Server used by stations on your LAN. The default is 0.0.0.0.
– Secondary DNS Se
rvers. The WNAP210 will use this IP address as the secondary
Domain Name Server used by stations on your LAN. The default is 0.0.0.0.
4. From
the pull-down menu, select the local Time Zone for your wireless access point from a
list of all available time zones. The default is GMT.-08:00
5. Check the Adjust for
Daylight Saving Time if your location uses daylight savings. The
default is no adjustment.
Note: If you do not have an Internet connection to get the current time, the wireless
access point will get the current time from the connecting PC.
6. Click Ap
ply to save your Basic IP settings.
Note: If you change the default subnet of the LAN IP address, you will be
disconnected from the Access Point user interface. To reconnect, reconfigure
your computer with a static IP address within the new LAN IP subnet.
By default, the WNAP210 is set with the DHCP client disabled. If your network uses dynamic IP
addres
ses, you must change this setting (see “Logging in to the Access Point” on page 2-12),
Configuring Your Wireless Settings
The following sections describe how to configure the wireless settings for both the 802.11b/g/Next
and 802.11b/g modes.
To configure the Access Point wireless settings of your wireless access
point:
1. From
the main menu under Setup, select Wireless Settings.The Wireless Settings screen will
display as shown in Figure 2-4 below