User Manual
Table Of Contents
- NETGEAR WNAP210 ProSafe Wireless-N Access Point Reference Manual
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
Figure 2-1
ProSafe Wireless-N Access Point WNAP210 Reference Manual
2-4 Installation and Configuration
v1.0, February 2009
3. Click OK. The main menu of the WNAP210 will display as shown in Figure 2-2.
• When the wireless access point is connected to the Inte
rnet, you can select the
Documentation link under the Web Support menu to view the documentation for the
wireless access point.
• When connected to the Internet, you can also sele
ct KnowledgeBase to access Application
Notes relevant to wireless networking.
• Select Logout to exit the WNAP210 setup screens.
(You will automatically be logged out
of the wireless access point after 5 minutes of no activity.)