User Manual
Table Of Contents
- NETGEAR WNAP210 ProSafe Wireless-N Access Point Reference Manual
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
ProSafe Wireless-N Access Point WNAP210 Reference Manual
Introduction 1-7
v1.0, February 2009
• Power adapter and cord (12 V dc, 1.0 A)
• Straight-through Category 5 Ethernet cable
• NETGEAR WNAP210 Wireless-N Access Point Installation Guide
• Resour
ce CD which includes this manual
• Wall mount kit
Contact your reseller or customer support in your
area if there are any missing or damaged parts.
You can refer to the Support Information Card for the telephone number of customer support in
your area. You should keep the Support Information card, along with the original packing
materials, and use the packing materials to repack the WNAP210 if you need to return it for repair.
To qualify for product updates and product warranty registrations, we encourage you to register on
the NETGEAR Web site at: http://www.netgear.com.
Hardware Description
This section describes the front and rear hardware functions of the WNAP210.
Front Panel
The WNAP210 front hardware functions are described below.
1
2
3
4
Figure 1-1