User's Manual

Wireless Router Setup Manual
10 Installing Your Wireless Router Manually (Advanced, Mac, and Linux Users)
of your computer. If you are unsure about this, refer to the documentation for your computer or see
the link to TCP/IP Addressing in “Related Documents” on page 39.
There are two steps to setting up your wireless router:
1. Connect the Product Family to the ADSL or cable modem, and connect a computer to the
Product Family.
2. Configure the Product Family to use your Internet service.
To connect your wireless router:
1.
Connect the wireless router, the computer, and the modem.
a. Turn off your computer.
b. Turn off and unplug the cable or ADSL broadband modem.
c. Locate the Ethernet cable (1) that connects your computer to the modem.
2. Disconnect the cable at the modem end only (2). You will connect it to the router later.
If you are replacing an existing router, disconnect it completely from your network
and set it aside before starting to install your new router.
Figure 6
1
2