User Manual

NETGEAR RangeMax Dual Band Wireless-N USB Adapter WNDA3100v2 User Manual
2-20
v1.0, December 2008
b. Use the icon to open the Wireless Assistant. The Settings tab displays:
2. Configure the Security settings.
a. In the Profile field, select the profile, or type in a profile name.
b. In the Network Name (SSID) field, and then select the network, or enter the SSID.
c. In the Security section, select WPA2-PSK [AES], and enter the passphrase.
For more about WPA2-PSK, see the link to “Wireless Communications:” in Appendix B.
3. Save your settings in a profile.
a. Click the Save Profile button. All the configuration settings are saved in this profile.
b. Click Apply, and then click Close to exit the Wireless Assistant.
Setting Up WEP Encryption Security
Follow the steps below to configure WEP encryption security:
1. Run the WNDA3100v2 Wireless Assistant.
a. Make sure that the WNDA3100v2 software is installed and the wireless USB adapter is
connected to the USB port in your computer.
Figure 2-22
Note: You will not get a wireless network connection unless the network SSID
matches exactly what is configured in the access point.