User's Manual

RangeMax Dual Band Wireless-N Modem Router DGND3300 User Manual
Safeguarding Your Network 2-15
v1.0, December 2008
To connect a combination of non-WPS enabled and WPS-Enabled clients to the modem router:
1. Restore the modem router to its factory default settings (press both the Wireless and WPS
buttons on the side of the modem router for 5 seconds).
When the factory settings are restored, all existing wireless clients are disassociated and
disconnected from the modem router.
2. Configure the network names (SSIDs), select the WPA/PSK + WPA2/PSK radio button on the
Wireless Settings screen (see “Manually Configuring Your Wireless Settings” on page 2-4).
and click Apply. On the WPA/PSK + WPA2/PSK screen, select a passphrase and click Apply.
Record this information to add additional clients.
3. For the non-WPS devices that you want to connect, open the networking utility and follow the
utility’s instructions to enter the security settings that you selected in Step 2 (the SSID, WPA/
PSK + WPA2/PSK security method, and passphrase).
4. For the WPS devices that you want to connect, follow the procedure “Using a WPS Button to
Add a WPS Client” on page 2-10 or “Using PIN Entry to Add a WPS Client” on page 2-12.
The settings that you configured in Step 2 are broadcast to the WPS devices so that they can
connect to the modem router.
5. To view a list of all devices connected to your modem router (including wireless and Ethernet-
connected), see “Viewing a List of Attached Devices” on page 4-9.
Note: To make sure that your new wireless settings remain in effect, verify that the
Keep Existing Wireless Settings checkbox is selected in the WPS Settings
screen.