User Manual
Table Of Contents
- NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual (802.11bgn)
- About This Manual
- Conventions, Formats and Scope
- How to Use This Manual
- How to Print this Manual
- Revision History
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Changing the Administrator Password
- Upgrading the Wireless Access Point Firmware
- Configuration File Management
- Rebooting the NETGEAR Wireless-N Access Point
- Viewing the Available Wireless Stations List
- Viewing General Summary Information
- Viewing Network Traffic Statistics
- Configuring the Advanced Wireless Settings
- Configuring the RADIUS Server Settings
- RADIUS Server Settings Fields
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Restore Factory Default Settings
- More Help
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual
6-2 Troubleshooting
v1.0, June 2008
• If the Wireless LAN activity light stays off, disconnect the adapter from its power source and
then plug it in again.
• Contact NETGEAR if the WLAN light remains off.
Figure 6-1 Turn Radio On button must be selected
I cannot configure the access point from a browser.
Check these items:
• The WN802Tv2 is properly installed, LAN connections are OK, and it is powered on. Check
that the LAN port LED is blinking green to verify that the Ethernet connection is OK.
• If DHCP is not enabled, make sure you are using the correct LAN IP address to access the
wireless access point, and that you are on the same network segment.
• If DHCP is enabled, configure your DHCP server with a reserved IP address (based on the
wireless access point’s MAC address). You can then use it to create a fixed IP address for the
wireless access point.