User Manual
Table Of Contents
- NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual (802.11bgn)
- About This Manual
- Conventions, Formats and Scope
- How to Use This Manual
- How to Print this Manual
- Revision History
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Changing the Administrator Password
- Upgrading the Wireless Access Point Firmware
- Configuration File Management
- Rebooting the NETGEAR Wireless-N Access Point
- Viewing the Available Wireless Stations List
- Viewing General Summary Information
- Viewing Network Traffic Statistics
- Configuring the Advanced Wireless Settings
- Configuring the RADIUS Server Settings
- RADIUS Server Settings Fields
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Restore Factory Default Settings
- More Help
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual
Advanced Wireless Bridging 5-7
v1.0, June 2008
4. Select the Repeater without Wireless Client Association radio button to enable this mode.
Down the left of the screen select the profile you want to add/edit, and click Edit.
Figure 5-5 Edit security profile
5. You are taken to the Edit Security Profile screen (see Figure 5-5). Enter a profile name or leave
the default. Enter the MAC (physical) address of the other bridge mode wireless access point
in the Remote MAC Address field.
6. Under Authentication Settings select a Network Authentication type. One of the supported
types (WEP, WPA-PSK, or WPA2-PSK) should be used to protect this communication.
7. From the Data Encryption drop-down menu select encryption strength.
8. Click Apply to save your settings.
9. You are taken back to the Wireless Bridge Settings screen (Figure 5-4) with the new profile
information. Enable the profile now if you wish to.
10. Click Apply to save your changes.
To configure a LAN segment utilizing the WN802Tv2 in Repeater Mode:
1. Configure the Operating Mode of the NETGEAR Wireless-N Access Points.
• Configure AP1 on LAN Segment 1 in Repeater mode with the Remote MAC Address of
the “downstream” remote AP (AP2).
• Configure AP2 in Repeater mode with the MAC address of the “upstream” AP (AP1).
2. Verify the following parameters for all access points: