User Manual
Table Of Contents
- NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual (802.11bgn)
- About This Manual
- Conventions, Formats and Scope
- How to Use This Manual
- How to Print this Manual
- Revision History
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Changing the Administrator Password
- Upgrading the Wireless Access Point Firmware
- Configuration File Management
- Rebooting the NETGEAR Wireless-N Access Point
- Viewing the Available Wireless Stations List
- Viewing General Summary Information
- Viewing Network Traffic Statistics
- Configuring the Advanced Wireless Settings
- Configuring the RADIUS Server Settings
- RADIUS Server Settings Fields
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Restore Factory Default Settings
- More Help
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual
Advanced Wireless Bridging 5-5
v1.0, June 2008
• That all wireless access points are using the same SSID, Channel, WEP authentication
mode, if any, and encryption (WPA is not available in bridge mode).
• That each Point-to-Point AP has the Multi-Point AP MAC address in its Remote AP MAC
address table.
• That the Multi Point-to-Point AP has the MAC addresses of each Point-to-Point AP.
• If Access Control has been enabled on the APs, verify that the Available Wireless Stations
list (MAC Address List,
Figure 3-10) for each AP is complete and accurate.
3. Verify connectivity across the LANs:
• That wireless clients are able to use the AP.
• A computer on any LAN segment should be able to connect to the Internet or share files
and printers with any other PCs or servers connected to any of the three LAN segments.
• If Access Control Lists are enabled on the APs, only computers in the access control list
will be able to use the AP.
Note: You can extend multi-point bridging by adding a total of six WN802Tv2 APs
configured in bridge mode to connect additional wireless LAN segments.
Configuring Repeater without Wireless Client Association
In this mode, the WN802Tv2 will operate as a Repeater only, and send all traffic to the remote
wireless access point. You must enter the MAC (physical) address of the remote wireless access
point.