User Manual
Table Of Contents
- NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual (802.11bgn)
- About This Manual
- Conventions, Formats and Scope
- How to Use This Manual
- How to Print this Manual
- Revision History
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Changing the Administrator Password
- Upgrading the Wireless Access Point Firmware
- Configuration File Management
- Rebooting the NETGEAR Wireless-N Access Point
- Viewing the Available Wireless Stations List
- Viewing General Summary Information
- Viewing Network Traffic Statistics
- Configuring the Advanced Wireless Settings
- Configuring the RADIUS Server Settings
- RADIUS Server Settings Fields
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Restore Factory Default Settings
- More Help
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual
Advanced Wireless Bridging 5-3
v1.0, June 2008
4. You are taken to the Edit Security Profile screen (see Figure 5-2). Enter a profile name or leave
the default. Enter the MAC (physical) address of the other bridge mode wireless access point
in the Remote MAC Address field.
Figure 5-2 Edit security profile
5. Under Authentication Settings, select one of the network authentication types from the
Network Authentication drop-down menu. One of the supported types (WEP, WPA-PSK, or
WPA2-PSK) should be used to protect this communication.
6. Select encryption strength from the Data Encryption options available.
7. Click Apply.
8. You are taken back to the Wireless Bridge Settings screen (Figure 5-1) with the new profile
information. Enable the profile now if you wish to.
You can add more wireless access points in the same way for a total of six. (These wireless
access points must be configured for Multi-Point Bridging.)
9. Click Apply to save your changes.