User Manual
Table Of Contents
- NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual (802.11bgn)
- About This Manual
- Conventions, Formats and Scope
- How to Use This Manual
- How to Print this Manual
- Revision History
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Changing the Administrator Password
- Upgrading the Wireless Access Point Firmware
- Configuration File Management
- Rebooting the NETGEAR Wireless-N Access Point
- Viewing the Available Wireless Stations List
- Viewing General Summary Information
- Viewing Network Traffic Statistics
- Configuring the Advanced Wireless Settings
- Configuring the RADIUS Server Settings
- RADIUS Server Settings Fields
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Restore Factory Default Settings
- More Help
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual
5-2 Advanced Wireless Bridging
v1.0, June 2008
1. Open a web browser and log in to the WN802Tv2 using the addressing scheme you have set
up.
.
Figure 5-1 Enable wireless bridging and repeating
2. Under the Configuration tab on the main menu, click Wireless Bridge. The Bridging and
Repeating screen displays showing the default settings for the wireless access point (
Figure 5-
1).
3. Check the Enable Wireless Bridging and Repeating checkbox to enable multi-point
bridging. Wireless Point to Multi-Point Bridge is the default mode. Down the left of the screen
select the profile you want to add/edit and click Edit.