User Manual
Table Of Contents
- NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual (802.11bgn)
- About This Manual
- Conventions, Formats and Scope
- How to Use This Manual
- How to Print this Manual
- Revision History
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Changing the Administrator Password
- Upgrading the Wireless Access Point Firmware
- Configuration File Management
- Rebooting the NETGEAR Wireless-N Access Point
- Viewing the Available Wireless Stations List
- Viewing General Summary Information
- Viewing Network Traffic Statistics
- Configuring the Advanced Wireless Settings
- Configuring the RADIUS Server Settings
- RADIUS Server Settings Fields
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Restore Factory Default Settings
- More Help
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual
4-6 Management
v1.0, June 2008
1. From the main menu of the browser interface, select Maintenance > Reset and then Reboot
AP on the side menu. The Reboot AP screen displays (Figure 4-5):.
Figure 4-5 Reboot the AP
2. Select the Yes radio button next to the Reboot option, and then click Apply.
Warning: Do not try to go online, turn off the Access Point, shut down the
computer or do anything else to the Access Point until it finishes
rebooting. When the power light turns green, wait a few more
seconds before doing anything with the Access Point.
To erase the current settings and reset the wireless access point to the original factory default
settings:
1. In Step 1 of the previous section, select Restore Defaults from the side menu (see Figure 4-
5).
2. Select the Yes radio button next to the Restore to factory default settings option.
3. Click Apply.