User Manual
Table Of Contents
- NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual (802.11bgn)
- About This Manual
- Conventions, Formats and Scope
- How to Use This Manual
- How to Print this Manual
- Revision History
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Changing the Administrator Password
- Upgrading the Wireless Access Point Firmware
- Configuration File Management
- Rebooting the NETGEAR Wireless-N Access Point
- Viewing the Available Wireless Stations List
- Viewing General Summary Information
- Viewing Network Traffic Statistics
- Configuring the Advanced Wireless Settings
- Configuring the RADIUS Server Settings
- RADIUS Server Settings Fields
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Restore Factory Default Settings
- More Help
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual
Management 4-5
v1.0, June 2008
To restore settings from a backup file:
1. In Step 1 of the previous section, click Restore Settings on the side menu..
Figure 4-4 Restore saved configuration settings
2. Click Browse at the Restore Saved Settings from a File box. Locate and select the previously
saved backup file (by default, Config).
3. Click Apply.
The wireless access point is restored to its previous settings and restarts. This takes about one
minute.
Warning: Do not try to go online, turn off the access point, shut down the
computer or do anything else to the access point until it finishes
restarting. When the PWR light turns green (access point has
rebooted), wait a few more seconds before doing anything with the
access point.
Rebooting the NETGEAR Wireless-N Access Point
You can reboot the wireless access point from the browser interface or by using the Reset button
on the rear panel (see
Figure 1-2 on page 1-6).
To reboot the wireless access point from the user interface: